 |
1-1/2" Round S-Steel & Brass
Post |
|
Flat Cap and Full Flange Base |
|
Standoffs hold 1/4" or 3/8" Glass |
|
10 Degree Slant - 18" Glass Height |
|
1/8" to 3 " Air Gap Under
Glass |
|
 |
| The Contemporary PP46 series
of partition posts are built from 1-1/2 inch round
Stainless Steel or Brass tubing. This series is
the same as the PP45 series, but is slanted by
10 degrees. It is available in 18" posts
as polished stainless, brushed stainless or Polished
Brass. The standard three configurations, End, Center,
and Corner are available. The post series
is shipped with a Flat Cap and Full Flange Base
with small standoff fittings glass clamps. These
clamps will hold 1/4" or 3/8" safety tempered glass.
The clamp location allows the air gap to be a maximun
of 3 inches and a minimun of 1/8 inch under the
glass. The post cap extends ~ 1/8 " above
the top edge of the glass. Use the EZ-Spec
Layout system order this post in cistom heights. |
|
|
